信息来源: | 发布日期: 2012-12-04 00:00:00 | 浏览量:205126
KS桨叶干燥机,污泥及副产品干燥 KS桨叶干燥机干燥产生干燥稳定的产品品种的污泥和产品,降低处置成本和将废物转化为适销对路的产品,全球范围内使用...
译文:KS桨叶干燥机,污泥及副产品干燥 KS桨叶干燥机干燥产生干燥稳定的产品品种的污泥和产品,降低处置成本和将废物转化为适销对路的产品,全球范围内使用。干燥也允许一些废物被用作燃料。
双计数器旋转轴与独特的啮合楔形桨产生均匀的加热和高热量的传输速率。使用空心桨叶传热结果,在一个紧凑的机器。间接加热用蒸汽或再循环的热流体(热油)的KS桨烘干机具有约98%的热效率。非冷凝性气体从干燥器可能需要治疗的气味是^小的。
原文:
K-S PADDLE DRYER FOR SLUDGE AND BY-PRODUCTS DRYING The K-S Paddle Dryer is used worldwide for drying a variety of sludges and by-products, generating dry stable products reducing disposal cost and converting waste into marketable by-products. Drying also allows some wastes to be used as fuel.
Dual counter rotating shafts with unique intermeshing wedge shaped paddles produce uniform heating and high heat transfer rates. The use of hollow paddles for heat transfer results in a compact machine. Indirectly heated with steam or recirculated thermal fluid (hot oil) the K-S Paddle Dryer has a thermal efficiency of approximately 98%. Non-condensable gas from the dryer that might require treatment for odors is minimal.
译文:应用: 机械脱水后,进一步减轻重量和热加工(干燥)的污泥,污泥,和副产物可以通过以下方式获得稳定的产品。 KS化工厂,石化厂,炼油厂,制药厂,食品加工厂,玉米湿磨工厂,乙醇设施,金属加工/整理厂,选矿厂,以及纸浆和造纸厂的经验。
达到90 +%的干燥固体(99 +%,如果需要的话) 实现中级干燥堆肥或焚烧 生产稳定,适销对路的产品 降低处置成本 提高燃油值 再加工残余物和尾矿 去除有害的挥发性有机化合物(热脱附) 生物污泥(污泥,废活性污泥(WAS)或生物固体) 生物污泥脱水,很难在堆填区处理的问题。热干燥污泥到第90 +%是可能的。此应用程序的详细信息KS生物固体干燥
初级沉淀池污泥和混合污泥 许多工厂生产初级污泥沉淀过程。这些淤泥可能会产生沉淀物的化学反应的结果。这种污泥可共混与二级生物污泥的较小部分。的机会是Komline - 桑德森的经验与您的污泥
肉类/家禽处理,明胶植物废物可以干燥,从而产生稳定的副产物。
金属氢氧化物滤饼,滤饼金属硫化物,氧化物和金属加工/加工植物和矿物处理厂的尾矿可与KS桨叶干燥机干燥。如果回收的金属是必须要做的,然后干燥,<1%(99 +%的干固物)所需的非常低的含水量。如果填土正在考虑中的80至85%干度,建议,如机材料可能会对多尘
土壤修复过程中受益于之前的更昂贵的高温工艺除去水和挥发性有机物质。这被称为热解吸
纸浆和造纸污泥 大多数工厂融合了小学和中学的污泥。 KS建议的污泥分离,所以硬盘的脱水污泥进行脱水和KS桨叶干燥机中干燥。这允许主纤维污泥脱水与一个螺旋压榨机的高固体浓度。这种方法也导致化学空调成本大大降低。配煤90 +%的干燥固体二次污泥与主污泥饼产生一个高品质的燃料的锅炉
脱墨厂的污泥含有细小纤维,填料和油墨KS桨叶干燥机的理想选择。干燥,以60%至70%双链这材料是一个极好的堆填区封盖材料
原文:After mechanical dewatering, further weight reduction and stable products can be obtained by thermal processing (drying) sludges, biosolids, and by-products. K-S has experience in chemical plants, petrochemical plants, refineries, pharmaceutical plants, food processing plants, corn wet milling plants, ethanol facilities, metal processing/finishing plants, mineral processing plants, and pulp & paper mills.
Achieve 90+% dry solids (99+% if desired) Achieve intermediate dryness for composting or incineration Produce stable and marketable products Reduce disposal cost Increase fuel value Re-process residuals and tailings Removal of hazardous volatile organic compounds (thermal desorption) Biological sludge (secondary sludge, waste activated sludge (WAS) or biosolids) Biological sludge is difficult to dewater, creating disposal problems at landfills. Thermal drying the sludge to 90+% is possible. For details on this application go to K-S Biosolids Dryer
Primary clarifier sludge and blended sludge Many industrial plants produce primary sludge from a settling process. These sludges may be the result of chemical reactions that produce precipitates. This sludge may be blended with a smaller portion of secondary biological sludge. Chances are Komline-Sanderson has experience with your sludge
Meat/poultry processing, Gelatin plant waste can be dried to produce stable by-products.
Metal Hydroxide filter cakes, metal sulfide filter cakes, oxides and tailings from metal processing/finishing plants and mineral processing plants can be dried with the K-S Paddle Dryer. If reclamation of the metal is to be done then drying to very low moistures <1% (99+% dry solids) is desired. If land filling is being considered dryness of 80 to 85 % is suggested, as dryer material might be dusty
Soil remediation processes benefit from the removal of water and volatile organic material prior to more costly high temperature processes. This is referred to as thermal desorption
Pulp and paper mill sludge Most mills blend the primary and secondary sludge. K-S recommends segregation of the sludges so the hard to dewater secondary sludge is dewatered separately and dried in the K-S Paddle Dryer. This allows dewatering of the primary fibrous sludge to a high solids concentration with a screw press. This approach also results in greatly reduced chemical conditioning cost. Blending 90+% dry solids secondary sludge with the primary sludge cake produces a high quality fuel for the boilers
De-inking mill sludges containing fine fiber, fillers and ink are ideal for the K-S Paddle Dryer. Dried to 60 to 70 % ds this material is an excellent landfill capping material.
正文结束!
金陵干燥专业生产干燥设备,2008年评为国内第一批^高新技术企业,已申请三十多项国家专利,七项高新技术产品...
宁夏某化工公司在江苏金陵干燥定购的PGZ-φ2500*20型盘式联系真空干燥机已发货。 盘式干燥机原理: ◆ 本公司独立开发设计生产的真空型连续盘…
四川某新材料有限公司在江苏金陵采购的非标混合干燥机组已发货,混合干燥机组包含ZXHG-2000锥形螺带干燥机1台、500L混合机1台。 锥型真空干燥机…
母亲节起源于希腊,古希腊人在这一天向希腊神话中的众神之母赫拉致敬。现代的母亲节起源于美国,于1908年5月10日在西弗吉尼亚和宾夕法尼亚州举行,在这…
江苏金陵生产制造的SZG-500型双锥回转真空干燥机发往潍坊某化工企业。 概述: ◆ 该机型是集混合(过滤)、干燥于一体,采用筒体旋转、夹套加…
广东客户发来热乎的现场反馈图,发酵罐、提取罐、种子罐、夹层锅生产线,用于肽的研究开发。 发酵罐是一种对物料进行机械搅拌与发酵的设备。该设备…
河北某生物化工有限公司采购的22台锥形螺带干燥机昨日再发5台10000L。 原理: ◆ 公司 于2008 年自行开创性研发生产了一种高真空单螺杆搅拌结…